INSTRUMENTS AND CONTROLS 241
gate operators, garage door openers, entry door locks, security systems, and even home lighting. The below steps are generic programming instructions; for Genie and Sommer garage door openers, please go directly to the HomeLink website. Additional information and programming videos can be found at www. HomeLink. com / Subaru and www. youtube. com / HomeLinkGentex.
CAUTION
. Before programming HomeLink to a garage door opener or gate operator, make sure that people and objects are out of the way of the device to prevent potential harm or damage.
. When programming a garage door opener, it is advised to park outside of the garage.
. Do not use HomeLink with any garage door opener that lacks safety stop and reverse features, as required by U. S. federal safety standards( this includes any garage door opener model manufactured before April 1, 1982). A garage door that cannot detect an object signaling the door to stop and reverse does not meet current U. S. federal safety standards.
. It is also recommended that a new battery be placed in the hand-held remote( garage door opener remote) of the device for quicker and more accurate training.
. Some vehicles may require the ignition switch to be turned to the“ ON” or“ ACC” position for programming and / or operation of HomeLink.
. Keep the hand-held remote( garage door opener remote) of the device you are programming for use in other vehicles as well as for future HomeLink programming. It is also suggested that upon the
sale of the vehicle, the programmed HomeLink buttons be erased for security purposes. Refer to“ Erasing HomeLink buttons”.
HomeLink set up:
HomeLink buttons Left button Center button Right button
S _ 308188-W
Press any of the left, center or right buttons to display the main menu. Select HomeLink menu using the left button or press any of the HomeLink buttons.
NOTE
The main menu cannot be displayed on the display while the select lever is in a position other than the“ P” position.
S _ 308189-W
1. Select“ SET UP” using the right button.
2. Select“ Continue” using the HomeLink left button.
– CONTINUED –
3