Illumination Brightness Control 181 |
|||||||
|
“ LOCK”/“ OFF” or“ ACC” position, the fuel gauge will light up and indicate the amount of fuel remaining in the tank. The gauge will turn off when the TRIP RESET switch is not operated for approximately 10 seconds.
& Engine Coolant Temperature Gauge s03ad08
1 Normal operating range
The temperature gauge shows engine coolant temperature when the ignition switch is in the“ ON” position.
The coolant temperature will vary in accordance with the outside temperature and driving conditions.
|
We recommend that you drive moderately until the pointer of the temperature gauge reaches near the middle of the range. Engine operation is optimum with the engine coolant at this temperature range and high revving operation when the engine is not warmed up enough should be avoided.
CAUTION
If the pointer exceeds the normal operating range, safely stop the vehicle as soon as possible.
Refer to“ Engine Overheating” FP496.
& Combination Meter Settings s03ad16
Meter settings can be set on the center information display. For details, perform the procedures described in“ General settings” FP227( 11.6-inch display models) or“ General settings” FP245( dual 7.0-inch display models).
|
3-5. Illumination Brightness Control |
s03aj
The illumination brightness of the combination meter and center information display dims under the following conditions.
. The light switch is in the“” or“” position when the ambient light is dark.
. The light switch is in the“ AUTO” position and the headlights illuminate automatically.
You can adjust the illumination brightness for better visibility.
To brighten, turn the control dial upward. To darken, turn the control dial downward.
|
3
Instruments and Controls
|
|||
– CONTINUED – |