466
Loading Your Vehicle
NOTE
The tightening torque is approximately 8.9 + 2.2 lbf · ft ( 12 + 3.0 N · m , 1.2 + 0.3 kgf · m ).
4 . Pull out the other side of the crossbar from the roof rail holder by pulling up the cover .
5 . Install both ends of the crossbar into the other holders .
7 . Install the plastic plug by pushing it into the hole until it is fully seated .
1 Guide plate 2 Torque wrench
6 . Using the torque wrench , tighten the crossbar bolts until the torque wrench hits the guide plate .
! How to re-stow bars CAUTION s08aj0803
Do not use the bars as roof rails when the bars are stowed .