124
Keyless Access with Push-Button Start System
NOTE
. Press the trunk opener button/rear
lock button ten times to enter “0”.
. Change the PIN code frequently to
protect your vehicle from theft.
. If you have lent your vehicle to
another person, confirm that the PIN
code has not been changed or deleted.
If the PIN code has been changed or
deleted, reregister a new PIN code.
. If you make an error during the
registration procedure, press the “ ”
or “ ” button on the access key fob.
Then, start over from the procedure
described in “Preparation”.
. To protect your vehicle from theft,
you cannot register “00000” to “99999”
or “12345” as a PIN code.
. Do not register your vehicle license
plate number or simple numbers such
as “11122” or “12121” as a PIN code.
Doing so will increase the risk of
vehicle theft.
. When you try to register “22222”, the
registered PIN code will be deleted. You
cannot unlock the doors by PIN Code
Access until a new code is registered.
. After registering a new PIN code,
make sure that you can unlock the
doors using the PIN code.
. The PIN code cannot be deleted
while the keyless access function is
disabled by operating the access key
fob.
. Reregister the PIN code in the following
case.
– When you forget the PIN code
– When you want to change the PIN
code
! Unlocking
s02ap2103
Perform steps (1) to (5) of step 5 described
in “Registration”.
NOTE
. You cannot unlock by PIN Code
Access in the following cases.
– When the access key fob is within
the operating ranges
– When the ignition switch is in the
“ACC” or “ON” position
. If you make an operation error during
the unlocking procedure, start over
with the unlocking procedure after
waiting for 5 seconds or longer.
. To protect your vehicle from theft, a
buzzer will sound if incorrect PIN codes
are entered five times continuously. If
this occurs, you cannot unlock the
doors by PIN Code Access for 5
minutes.
& Power Saving Function
s02ap23
To protect the access key fob battery and
the vehicle battery, the keyless access
function will be disabled as follows.
. When the keyless access function and
the remote keyless entry system have not
been used:
(1) 5 days after the push-button ignition
switch has been turned off, communication
between the antennas and
the access key fob will be stopped.
(2) 9 days after step (1), the sensors
(both lock sensor and unlock sensor)
on the front passenger’s door will be
disabled.
. When the access key fob has been left
in the operating range for 10 minutes or
longer while all doors are locked, the
keyless access function will be disabled.
! Recovery from power saving mode
s02ap2301
When one of the following operations is
performed, the keyless access function
will be recovered.
. Unlock by gripping the door handle
(only when the sensors on the front
passenger’s door are not disabled) or
pressing the rear gate opener button on
the rear gate (Outback)/trunk opener
button on the trunk lid (Legacy)
. Lock or unlock by the remote keyless