146
Child Safety Locks
setting will then be changed as follows .
Setting status
Combination meter display ( color LCD )
Horn
Activate |
AL ON |
Once |
Deactivate |
AL OFF |
Twice |
NOTE
You may have the above setting change done by your SUBARU dealer .
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations :
. Press any button on the access key fob / remote transmitter .
. Turn the ignition switch to the “ ON ” position ( models without “ keyless access with push-button start system ”).
. Turn the push-button ignition to the “ ACC ” position ( models with “ keyless access with push-button start system ”).
NOTE
Only registered keys will stop the alarm . If the immobilizer transponder is not registered , the alarm will not stop .
& Valet Mode s02af06
When you choose the valet mode , the alarm system does not operate . In valet mode , the remote transmitter is used only for locking and unlocking the doors and rear gate ( Outback / Subaru Outback Wilderness ) and panic activation .
To enter the valet mode , change the setting of your vehicle ’ s alarm system to deactivation mode . Refer to “ Alarm System Setting ” FP145 . The security indicator light will continue to flash once every 3 seconds , indicating that the system is in the valet mode .
To exit valet mode , change the setting of your vehicle ’ s alarm system to activation mode . Refer to “ Alarm System Setting ” FP145 .
2-7 . Child Safety Locks
WARNING s02ag
Always turn the child safety locks to the “ LOCK ” position when children sit on the rear seat . Serious injury could result if a child accidentally opens the door and falls out .
Each rear door has a child safety lock . When the child safety lock lever is in the “ LOCK ” position , the door cannot be opened from inside . The door can only be opened from the outside .