Alarm System 145 |
||||
Always make sure that they are fully closed before arming the system . . The 30-second standby time can be eliminated if you prefer . Have it performed by your SUBARU dealer . . If any of the following actions is done during the standby period , the system will not switch to the surveillance state . – Doors ( including the rear gate ( Outback / Subaru Outback Wilderness )/ trunk lid ( Legacy )) are unlocked using the access key fob / remote transmitter . – Doors ( including the rear gate ( Outback / Subaru Outback Wilderness )/ trunk lid ( Legacy )) are unlocked using the keyless access function ( models with “ keyless access with push-button start system ”). – Any door ( including the rear gate ( Outback / Subaru Outback Wilderness ) and engine hood ) is opened . – The ignition switch is turned to the “ ON ” position ( models without “ keyless access with push-button start system ”). – Push-button ignition switch is turned to the “ ACC ” position ( models with “ keyless access with pushbutton |
start system ”).
& Disarming the System s02af05
Perform either of the following procedures .
. Briefly press a button ( for less than 2 seconds ) on the access key fob / remote transmitter .
. Carry the access key fob and perform either of the following procedures ( models with “ keyless access with push-button start system ”). – Grip the front door handle . – Press the rear gate opener button ( Outback / Subaru Outback Wilderness ). – Press the trunk opener button ( Legacy ). – Unlock using the PIN code access .
The flashing of the security indicator light will then change slowly ( once approximately every 3 seconds from twice approximately every 2 seconds ), indicating that the alarm system has been disarmed .
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob / transmitter ( i . e ., the transmitter is lost , broken or the transmitter battery is too weak ), you can disarm the system without using the access key fob / remote transmitter .
|
The system can be disarmed if you turn the ignition switch from the “ LOCK ”/“ OFF ” position to the “ ON ” position with a registered key / access key fob .
NOTE
For models with “ keyless access with push-button start system ”, if the access key fob battery is discharged , perform the procedure described in “ Switching Power Status ” FP496 . In such a case , replace the battery immediately . Refer to “ Replacing Battery of Access Key Fob ” FP555 .
|
& Alarm System Setting s02af11
To change the setting of your vehicle ’ s alarm system for activation or deactivation , do the following .
1 . Disarm the alarm system . Refer to “ Disarming the System ” FP145 .
2 . Sit in the driver ’ s seat and shut all doors , the rear gate ( Outback / Subaru Outback Wilderness ), the trunk lid ( Legacy ) and engine hood .
3 . Turn the ignition switch to the “ ON ” position .
4 . Hold down “ ” of the driver ’ s power door locking switch , open the driver ’ s door within the following 1 second , and wait 10 seconds without releasing the switch . The
|
2
Keys and Doors
|
– CONTINUED – |