2-18
Keys and doors/Keyless access with push–button start system
8. Within 5 seconds after step 7 is
performed, close the door. A chirp sound
will be heard, and the functions will be
disabled.
NOTE
In steps 4 and 6, press the power door
locking switch slowly. If the switch is
pressed quickly, the functions may not
be disabled.
! Enabling functions
When the procedure to disable the functions is performed again, the functions are
enabled.
NOTE
. The keyless access function will be
enabled only if you perform the procedure in the same manner that you
disabled the function (for example,
when disabling by operating the driver’s door, the function will not be
enabled even if you operate the access
key).
. Press the push-button ignition
switch if you do not know the procedure in which the keyless access
function was disabled.
– When disabling by operating the
driver’s door: a chirp will not be
heard
– When disabling by operating the
access key: a chirp will be heard
& When access key does not
operate properly
Refer to “Access key – if access key does
not operate properly” F9-17.
& Replacing battery of access
key
Refer to “Replacing battery of access key”
F11-45.
& Replacing access key
Access keys can be replaced at SUBARU
dealers. For more details, contact a
SUBARU dealer.
& Certification for keyless access with push-button start
system
! U.S.-spec. models
FCC ID: HYQ14AHC
FCC ID: HYQ13CZZ
FCC ID: Y8PSSPIMB02
FCC ID: Y8PSSPLF02
CAUTION
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the
equipment.
NOTE
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.