Keys and doors/PIN Code Access (models with “keyless access with push–button start system”)
! Canada-spec. models
NOTE
This device complies with Industry
Canada licence-exempt RSS standard
(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
PIN Code Access (models
with “keyless access with
push-button start system”)
NOTE
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d’en compromettre le fonctionnement.
1)
Rear lock button
When all doors and the rear gate are
locked, you can unlock them without a key
by operating the rear lock button. You
need to register a PIN code to your vehicle
before using this function.
NOTE
PIN Code Access will be helpful if the
key is accidentally left in the vehicle. It
is recommended that a 5-digit security
code (PIN code) is registered.
2-19
& Registering a PIN code
! Preparation
1. Close all doors and the rear gate.
2. Press and hold the “ ” button on the
access key. Then all doors and the rear
gate will be locked.
3. Keep the “ ” button pressed, and
press the rear lock button within 5
seconds after step 2.
4. Press and hold the above button for
more than 5 seconds. Then a chirp will
sound.
5. Release the “ ” button and the rear
lock button.
6. Press the “ ” button on the access key
while the chirp sounds.
Then the chirp will stop and the preparation is complete.
NOTE
If you do not press the “ ” button on
the access key, the chirp will sound for
30 seconds. In this ca 6R