Mirrors 249 |
|||||||
|
Compass calibration zones( South America)
3. To adjust for compass zone variance:( 1) Find your current location and zone number on the map.
( 2) Press and hold the“” switch for more than 6 seconds or until a zone number appears in the display.
( 3) Once the zone number appears in the display, toggle the“” switch again until your current location zone number appears. After you stop pressing the switch, your new zone number will be saved. Within a few seconds, the display will show a compass direction.
4. If the vehicle’ s magnetics have changed or if the compass appears inaccurate
|
, recalibrate the compass. Press and hold the“” switch for more than 9 seconds or until a“ C” appears in the display. Once a“ C” appears in the display, slowly drive the vehicle in circles until compass is calibrated. |
! HomeLink ® Wireless Control System s03ap0704
The HomeLink ® Wireless Control System provides a convenient way to replace up to three hand-held radio frequency remotes used to activate devices such as gate operators, garage door openers, entry door locks, security systems, even home lighting. The below steps are generic programming instructions; for Genie and Sommer garage door openers please go directly to the HomeLink ® website. Additional information and programming videos can be found at www. HomeLink. com and www. youtube. com / HomeLink- Gentex.
CAUTION
. Before programming HomeLink ® to a garage door opener or gate operator, make sure that people and objects are out of the way of the device to prevent potential harm or damage.
|
. When programming a garage door opener, it is advised to park outside of the garage.
. Do not use HomeLink ® with any garage door opener that lacks safety stop and reverse features as required by U. S. federal safety standards( this includes any garage door opener model manufactured before April 1, 1982). A garage door that cannot detect an object signaling the door to stop and reverse does not meet current U. S. federal safety standards.
. It is also recommended that a new battery be placed in the handheld remote( garage door opener remote) of the device for quicker and more accurate training.
. Turn the ignition switch to the“ ON” or“ ACC” position before programming and / or operating HomeLink ®.
. Keep the hand-held remote( garage door opener remote) of the device you are programming for use in other vehicles as well as for future HomeLink ® programming.
|
3
Instruments and Controls
|
|||
– CONTINUED – |