Alarm System 133 |
|||||||||||
|
out “ keyless access with pushbutton start system ”).
– Push-button ignition switch is turned to the “ ACC ” position ( models with “ keyless access with push-button start system ”).
& Disarming the System s02af05
Perform either of the following procedures .
. Briefly press unlock / disarm button ( for less than 2 seconds ) on the access key fob / remote transmitter .
. Carry the access key fob and perform either of the following procedures ( models with “ keyless access with push-button start system ”). – Grip the front door handle . – Press the rear lock button . – Unlock using the PIN Code Access .
The flashing of the security indicator light will then change slowly ( once approximately every 3 seconds from twice approximately every 2 seconds ), indicating that the alarm system has been disarmed .
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob / transmitter ( i . e ., the transmitter is lost , broken or the transmitter battery is too weak ), you can disarm the system without using the access key fob /
|
remote transmitter .
The system can be disarmed if you turn the ignition switch from the “ LOCK ”/“ OFF ” position to the “ ON ” position with a registered key / access key fob .
NOTE
For models with “ keyless access with push-button start system ”, if the access key fob battery is discharged , perform the procedure described in “ Switching Power Status ” FP443 . In such a case , replace the battery immediately . Refer to “ Replacing Battery of Access Key Fob ” FP499 .
|
& Alarm System Setting s02af11
To change the setting of your vehicle ’ s alarm system for activation or deactivation , do the following .
1 . Disarm the alarm system . Refer to “ Disarming the System ” FP133 .
2 . Sit in the driver ’ s seat and shut all doors , the rear gate and engine hood .
3 . Turn the ignition switch to the “ ON ” position .
4 . Hold down “ ” of the driver ’ s power door locking switch , open the driver ’ s door within the following 1 second , and wait 10 seconds without releasing the switch . The setting will then be changed
|
as follows .
Setting status
Combination meter display ( color LCD )
Horn
NOTE
You may have the above setting change done by your SUBARU dealer .
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations :
. Press any button on the access key fob / remote transmitter .
. Turn the ignition switch to the “ ON ” position ( models without “ keyless access with push-button start system ”).
. Turn the push-button ignition to the “ ACC ” position ( models with “ keyless access with push-button start system ”).
NOTE
Only registered keys will stop the alarm . If the immobilizer transponder is not registered , the alarm will not stop .
|
2
Keys and Doors
|
|||||||
– CONTINUED – |