Light Control Switch 235 |
||||||||||||
& Headlight Flasher |
CAUTION |
s03ah03 |
Do not hold the lever in the flashing position for more than just a few seconds .
To flash the headlights , pull the lever toward you and then release it . The high beam will stay on for as long as you hold the lever . The headlight flasher works even though the lighting switch is in the off position .
When the headlights are on high beam , the high beam indicator light “ ” on the combination meter also illuminates .
|
& High Beam Assist Function s03ah07
NOTE
. The high beam assist function utilizes the stereo camera installed at the position of the front map lights .
. For details on how to handle the stereo camera , refer to the Owner ’ s Manual supplement for the EyeSight system .
The high beam assist function automatically changes the headlight from high beam to low beam ( or vice versa ).
When all of the following conditions are met , the headlight will change to high beam .
. When the vehicle speed increases to or above 20 mph ( 32 km / h ).
. There is no preceding or oncoming vehicle .
. The forward area of the vehicle is dark . . The road does not have a sharp curve .
When any of the following conditions are met , the headlight will change to low beam .
. When the vehicle speed decreases to or below 10 mph ( 16 km / h ).
. When the forward area of the vehicle is bright .
. When there is a preceding or oncoming vehicle .
|
. When the EyeSight system is malfunctioning or is temporarily stopped .
NOTE
. Do not overestimate the capacity of the high beam assist function . The driver always has the responsibility to understand the surrounding situation , to drive safely , and to change the headlight mode manually if necessary .
. The factory setting ( default setting ) for this function is set as “ operational ”. This setting can be changed to OFF ( non-operation ) at SUBARU dealers . For more details , contact a SUBARU dealer .
! How to use the high beam assist function s03ah0701
The high beam assist function will be activated when all the following conditions are met .
. The light control switch is in the “ AUTO ” position and the low beam headlights are on automatically .
. The turn signal lever is pushed forward .
|
3
Instruments and Controls
|
||||||
– CONTINUED – |