Keys and doors / Keyless access with push-button start system 2-7
When the access key fob is within either of the operating ranges of the front doors , the LED indicator on the access key fob flashes . When the keyless access functions are disabled , the LED indicator does not flash unless a button on the access key fob is pressed .
NOTE
. If the access key fob is placed too close to the vehicle body , the keyless access functions may not operate properly . If they do not operate properly , repeat the operation from further away . . If the access key fob is placed near the ground or in an elevated location from the ground , even if it is in the indicated operating range , the keyless access function may not operate properly . . When the access key fob is within the operating range , it is possible for anyone , even someone who is not carrying the access key fob , to operate the keyless access function . Note that the keyless access function can be operated only by the door handle , door lock sensor , rear gate opener button or rear lock button in the operating range in which the access key fob is detected . . It is not possible to lock the doors and rear gate using the keyless access function when the access key fob is inside the vehicle . However , depending on the status of the access key fob and the environmental conditions , the access key fob may be locked inside the vehicle . Before locking the vehicle , make sure that you have the access key fob . . When the battery of the access key fob is discharged , or when operating it in a location with strong radio waves or noise ( e . g ., near a radio tower , power plant , broadcast station or an area where wireless equipment is used ), or while talking on a cell phone , the operating ranges may be reduced , or the keyless access function may not operate . In such a case , perform the procedure described in “ Locking and unlocking ” F9-18 . . The doors may lock or unlock when the car is being washed or exposed to a significant amount of water that contacts the door handle while the key fob is still in the operating range .
! How to lock and unlock
S02AP2002
It is possible to perform the following operations when you are carrying the access key fob .
. Lock and unlock the doors .
. Unlock and lock the rear gate .
NOTE
. It is not possible to lock the doors and rear gate using the keyless access function when the push-button ignition switch is in the “ ACC ” or “ ON ” position . Refer to “ Switching power status ” F3- 7 . . If the door handle is gripped with a gloved hand , the door lock may not be released . . If the door lock sensor is touched three times or more repeatedly , the system will ignore the sensor operation . . When performing the locking procedure too quickly , locking may not have been completed . After performing the locking procedure , it is recommended to pull the REAR door handle to confirm that the doors have been locked . . If any of the doors ( or the rear gate ) are not fully closed , the following will occur to alert you that the doors ( or the rear gate ) are not properly closed . – An electronic chirp sounds five times . – The hazard warning flashers flash five times . . It is possible to lock the doors even when one of the doors is open . After
– CONTINUED –