Instruments and controls/Meters and gauges
Meters and gauges
NOTE
Some of the meters and gauges on the
combination meter use liquid-crystal
displays. You will find their indications
hard to see if you wear polarized
glasses.
& Combination meter illumination
When the ignition switch is turned to the
“ON” position, various parts of the combination meter will illuminate in the following
sequence.
& Canceling the function for
meter/gauge needle movement upon turning on the
ignition switch
3-9
The display can be switched as shown in
the following sequence by pressing the
trip knob.
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when th e
ignition switch is turned to the “ON”
position.
! Type A combination meter
To change the setting, perform the following procedure.
1. Turn the ignition switch to the “LOCK”/
“OFF” or “ACC” position.
1. Warning lights, indicator lights, meter
needles, gauge needles and liquid crystal
display illuminate.
2. Meter and gauge indications each
show MAX position.
3. Meter and gauge indications each
show MIN position.
4. Regular illumination (for driving) begins.
*: They cannot be displayed when the
ignition switch is in the “ON” position.
To change the current setting, press the
trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
1)
. Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation “ ” at
the time of shipment from the factory.
. It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the “ON” position. Change the setting
when the ignition switch is in the
“LOCK”/“OFF” or “ACC” position.
Trip knob
2. Press the trip knob to show “
“ ” on the trip meter display.
” or
– CONTINUED –