In case of emergency/In case of a flat tire
9. Secure the sealant bottle (4) to the
compressor with Velcro to keep the bottle
upright.
NOTE
It might not be possible to use the
sealant if the bottle falls over. Make
sure the bottle remains upright.
10. Insert the power cord of the compressor (3) into the accessory power outlet
(10).
CAUTION
Be sure to power the compressor
only from the accessory power outlet.
11. Set the ignition switch to the “ACC”
position.
9-9
12. Once again check the sidewall of the
tire for cracks, bumps, or similar damage
before starting the compressor. If there is
no such damage, press the “ ” (on) side
of the compressor’s power switch (1) and
inject the sealant and air.
CAUTION
. When injecting sealant, the pressure will exceed 45 psi (300 kPa)
temporarily and then decrease
when all the sealant enters the
tire.
. Do not stand directly next to the
tire while the sealant is being
injected.
. After some sealant and air have
inflated the tire partially, check
– CONTINUED –