9-10
In case of emergency/In case of a flat tire
the sidewall of the tire for cracks
and bumps. If any cracks,
bumps, or similar damage appears in the sidewall while using
the compressor, stop the compressor immediately and press
the air vent button to release the
pressure. In this case, you cannot repair the tire with the flat tire
repair kit. Contact a SUBARU
dealer or Commercial Road Service for assistance.
CAUTION
. Do not attach the speed limit
label to the steering wheel pad
or the dashboard. The label could
interfere with proper operation of
the SRS airbag.
. Do not attach the label in locations where it will block warning
indicators or the speedometer.
tire might be damaged severely. In
this case, you cannot repair the tire
with the flat tire repair kit. Contact a
SUBARU dealer or Commercial
Road Service for assistance.
15. Simultaneously, remove the valve fitting (9) on the tip of the application cap’s
rubber hose (8) from the valve while
pushing the air vent button (11) on the
compressor.
13. Attach the speed limit (50 mph (80
km/h)) label in a location where it can be
seen easily by the driver.
14. Press the “ ” (off) side of the power
switch (1) when the tire pressure reaches
26 psi (180 kPa).
CAUTION
If the tire pressure does not reach 26
psi (180 kPa) after 10 minutes, the
CAUTION
Remove the fitting quickly.
16. Reattach the tire valve cap.