264
Mirrors
5. To erase the program for the HomeLink button, select“ Clear” using the HomeLink center button.
HomeLink is now ready to be programmed at any time beginning with“ Programming a new HomeLink button”- step 1.
! |
Reprogramming |
a |
Single |
|
HomeLink Button |
|
|
|
S03AP110806
To program a previously programmed
|
HomeLink button refer to“ HomeLink set |
up” FP261. |
! Garage Door Two-Way Communication
S03AP110807
HomeLink has the capability of communicating with your garage door opener. HomeLink can receive and display“ closing” or“ opening” status messages from compatible garage door opener systems. At any time, HomeLink can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being“ closed” or“ opened”.
HomeLink has the capability of receiving this communication from the garage door opener at a range up to 820 feet( 250 m). Range may be reduced by obstacles such as houses or trees. You may have to slow your vehicle speed to successfully receive the garage door opener communication.
! Programming Two-Way Communication
S03AP110808
1 Status Indicators
Within five seconds after programming a new HomeLink button, both of HomeLink’ s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled. If your garage door status indicators flashed, two-way communication programming is complete.
If the garage door status indicators do not flash, additional HomeLink information and programming videos can be found online at www. HomeLink. com / Subaru and www. youtube. com / HomeLinkGentex.