Light control switch 233 |
||||
|
Canada models ). When approaching :
While the welcome lighting function is activated , the low beam headlights will automatically illuminate when unlocking all doors including the rear gate by using the remote keyless entry system .
The low beam headlights will remain illuminated for 30 seconds * 1 and then turn off . However , if any of the following operations is done , the low beam headlights will turn off .
. The doors are locked .
. The light control switch is turned to a position other than “ AUTO ”.
. The ignition switch is turned to the “ ON ” position .
When exiting :
While the welcome lighting function is activated , the low beam headlights will remain illuminated even when either of the following operation is done .
. The push-button ignition switch is turned to the “ OFF ” status ( models with “ keyless access with push-button start system ”).
. The key is pulled out from the ignition switch ( models without “ keyless access with push-button start system ”).
|
The low beam headlights will turn off under any of the following conditions .
. 3 minutes have passed since the low beam headlights were illuminated by the welcome lighting function .
. 30 seconds have passed since the door is opened and closed . * 1
. The light control switch is turned to a position other than “ AUTO ”.
. The locking procedure is performed twice . When performing the unlocking procedure after performing the locking procedure , perform the locking procedure twice again .
* 1 : The setting for the period of time in which the low beam headlights remain on by the welcome lighting function can be changed by a SUBARU dealer . Contact your SUBARU dealer for details . Also , you can change the setting by operating the center information display . For details , refer to “ Car settings ” FP215 .
|
! Sensor for the auto on / off headlights
S03AH0101
|
The sensor is as shown in the illustration .
CAUTION
If any object is placed on or near the sensor , the sensor may not detect the level of the ambient light correctly and the auto on / off headlights may not operate properly .
|
Instruments and controls |
– CONTINUED – |