• HEALTH AND SAFETY
Over- or under-tensioning and / or extending blade changes for too long can lead to spillage. the belt and the pulley face, repeatedly cycling and causing more damage. Along with decreasing the belt ' s lifespan, dust and fines can get into these blemishes and contaminate the pulley face.
When a roller or pulley face becomes fouled, it is covered with abrasive grit that can wear down and damage the belting over time. In some cases, fouling causes slippage, which can disrupt the smooth operation of the belt and lead to mistracking.
Recommendation: If there is sufficient space, install secondary and tertiary cleaners to guarantee the belt is thoroughly clean on the return. To enhance safety, consider units that allow a single worker to pull them away from the stringer for quicker external servicing. Consider placing a diagonal or V-shaped plow underneath the loading zone just before the tail pulley, which rides on the underside of the belt and removes any loose material. For more effective cleaning and to lessen friction damage, opt for a plow with torsion arms instead of one held in place by chains. Install belt trackers or crown rollers along the upper and lower belt paths to maintain proper alignment.
Innovative cleaner designs require less monitoring and no tensioning.
Scraper in action.
Reducing carryback Anything that sticks to the return side of the belt and moves with it is considered carryback, which can cause serious damage to a system. Not only is it a major source of fugitive dust and fines, but it also easily migrates into return rollers and takeup pulleys, fouling the bearings, drives and the face of the roller. The grit grinds down roller bearings and leads to excessive friction heat, causing them to become mis-shapen and seize.
Like spillage, carryback can migrate to the underside of the belt that doesn ' t carry material. These chunks travel all the way to the tail pulley. The intense pressure between the pulley and the belt causes the hard, sharp mass to damage the vulnerable side of
A clogged transfer chute or hopper is one of the most dangerous situations in bulk handling.
The plow diverts fugitive carryback to either side of the system, ensuring tail pulley health.
Safely addressing bulk handling clogs A clogged transfer chute or hopper is one of the most dangerous situations in bulk handling. Untrained and uncertified personnel should never enter a clogged chute or bin under any circumstances. A sudden discharge can be deadly, as an unknown void can engulf and crush a worker. Material adhered vertically to the sides can loosen and cause a sheet of debris to fall on someone inside the vessel.
Buildup points in chutes include:
• Rockboxes – shelves, even if they’ re sloped, can experience buildup.
• Exit gates or doors – since these help control flow, they are also prone to clogging.
• Sloped points – located under the secondary cleaner, chute grades, or at choke points.
• Metal surface grain – the metal grain of chute plating should align with the flow of cargo.
• Exposed surfaces – surfaces where moisture can gather and lead to buildup.
• Damaged surfaces – surfaces with scratches, dents, creases or divots.
26 • African Mining • November 2025 www. africanmining. co. za