African Mining November 2025 | Page 27

HEALTH AND SAFETY • silo or pile or a transport vehicle. The primary cleaner is installed after the discharge stream to remove any material that may have adhered due to the cargo ' s weight or properties such as moisture, cohesion or heat. A secondary cleaner removes dust and fines from divots and cracks in the belt. Material cleaned by the secondary cleaner is typically directed onto a sloped surface connected to the transfer chute.
Obvious signs of discharge inefficiency include spillage, carryback, chute clogging and dust. Each of these alone can cause a workplace safety violation, but together they lead to unscheduled downtime and higher operating costs. From an operational perspective, three of the costliest issues are workplace injuries, belt damage from friction, and the replacement of fouled equipment.
Consider placing a diagonal or V-shaped plow underneath the loading zone just before the tail pulley, which rides on the underside of the belt and removes any loose material.
fouls rollers, it causes them to freeze, leading to friction and highheat damage to the vulnerable return side of the belt, reducing the equipment’ s lifespan. To prevent belt fires and dust explosions, seized idlers and rollers should be maintained and replaced immediately, making clear access to the system essential.
Cleaning up spills can be expensive, distract staff from other important tasks, and pose a workplace safety risk if workers are cleaning around a moving belt. What might seem like a simple job at first, such as shovelling spill material back into the cargo stream or into bins, demands more effort over time as the problem gets worse. Using machinery like front loaders or industrial vacuums to clear material can accidentally cause contact with the stringer or supports, which could lead to belt mistracking.
Spillage at the discharge zone can require extra equipment and labour to clean up.
Spillage and safety Primary cleaners or“ scrapers” can fail in several ways, causing adhered coarse aggregate and caked fines to pass by the blade and spill around the discharge area. This fugitive material can build up quickly and encapsulate the belt, fouling rolling components and causing the belt to ride on top of the course pile, leading to serious belt damage and increased belt temperatures from friction.
Fugitive material spills onto walkways, blocking access for maintenance and creating a trip and fall hazard. When coarse grit
To prevent belt fires and dust explosions, seized idlers and rollers should be maintained and replaced immediately, making clear access to the system essential.
Mistracking can be a major cause of spillage, not just along the belt path but also at the discharge point. The blade is centred on the head pulley, but if the belt isn ' t, adhered material can cause spillage.
Recommendation: Install a belt tracker at a distance of 3 to 4 times the width of the belt before the head pulley as the trough angle flattens, to ensure the belt hits the centre of the head pulley.
Over- or under-tensioning and / or extending blade changes for too long can lead to spillage. Over-tensioning causes quick wear on the belt / splice and reduces blade lifespan. Undertensioning allows material to pass without being properly removed. Ignoring primary cleaners for too long can result in pull-through, where the belt ' s force causes the blade to face the opposite direction and, in some cases, break off.
Recommendation: Enter into a service agreement with the blade manufacturer to regularly monitor, tension and replace the blades as needed. Consider installing a modern assembly that allows workers to slide units from the stringer for quick and easy one-person blade changes. There is also the option of innovative cleaner technology with four times the lifespan of the standard primary blade and no tensioning required for the life of the blade.
www. africanmining. co. za African Mining Publication African Mining African Mining • November 2025 • 25