626 8-2. Steps to take in an emergency
17Attach the air release cap to the end of the hose.
21Turn the compressor switch on and wait for several seconds, then turn it off. Check the tire inflation pressure.
If the air release cap is not attached, the sealant may leak and the vehicle may get dirty.
18Temporarily store the bottle in the luggage compartment while it is connected to the compressor.
19To spread the liquid sealant evenly within the tire, immediately drive safely for about 3 miles( 5 km) below 50 mph( 80 km / h).
20After driving, stop your vehicle in a safe place on a hard, flat surface and reconnect the repair kit.
Remove the air release cap from the hose before reconnecting the hose.
A If the tire inflation pressure is under 19 psi( 130 kPa, 1.3
kgf / cm 2 or bar): The puncture cannot be repaired. Contact your SUBARU retailer.
B If the tire inflation pressure is
19 psi( 130 kPa, 1.3 kgf / cm 2 or bar) or higher, but less than the specified air pressure: Proceed to step 22.
C If the tire inflation pressure is the specified air pressure( �P. 649): Proceed to step 23.
22Turn the compressor switch on to inflate the tire until the specified air pressure is reached. Drive for about 3 miles( 5 km) and then perform step 20.
23Attach the air release cap to the end of the hose.
If the air release cap is not attached, the sealant may leak and