8-2. Steps to take in an emergency
627 the vehicle may get dirty. protrusion on the air release cap into the valve to let some air out.
24Store the bottle in the luggage compartment while it is connected to the compressor.
25Taking precautions to avoid sudden braking, sudden acceleration and sharp turns, drive carefully at under 50mph( 80 km / h) to the nearest SUBARU retailer that is less than 62 miles( 100 km) away for tire repair or replacement.
For repair and replacement of a tire or disposal of the tire puncture
repair kit, contact your SUBARU retailer.
When having the tire repaired or replaced, make sure to tell the SUBARU retailer that the sealant is
injected.
n If the tire is inflated to more than the specified air pressure
1 Disconnect the hose from the valve.
2 Install the air release cap to the end of the hose and push the
3 Disconnect the hose from the valve, remove the air release cap from the hose and then reconnect the hose.
4 Turn the compressor switch on
and wait for several seconds, then turn it off. Check that the air
pressure indicator shows the
specified air pressure is reached.( �P. 649)
If the air pressure is under the
designated pressure, turn the compressor switch on again and
repeat the inflation procedure
until the specified air pressure is reached.
nAfter a tire is repaired with the emergency tire puncture repair kit
lThe tire pressure warning valve
and transmitter should be replaced.
lEven if the tire inflation pressure is at the recommended level, the tire
pressure warning light may come on / flash.
WARNING n When fixing the flat tire
lStop your vehicle in a safe and flat area.
8
When trouble arises