542 6-4. Using the other interior features
6 Repeat the steps above to program another device for any of the remaining Home-
Link ® buttons.
■ Programming a rolling code system
Two or more people may be needed to complete rolling code programming. 1 Locate the“ Learn” or“ Smart” button on the garage door opener motor in the garage.
This button can usually be found where the hanging antenna wire is
attached to the unit. The name and color of the button may vary by manufacturer. Refer to the owner’ s
manual supplied with the garage door opener motor for details.
3 Press and hold the desired
HomeLink ® button( inside the vehicle) for 2 seconds and release it. Repeat this sequence( press / hold / release) up to 3 times to complete programming. If the garage door opener motor operates when the
HomeLink ® button is pressed, the garage door opener motor recognizes the
HomeLink ® signal.
� Vehicles with auto anti-glare inside rear view mirror
2 Press and release the“ Learn” or“ Smart” button.
Perform 3 within 30 seconds after performing 2.
� Vehicles with Digital inner mirror