Create Layers
Tell us what you think! Send your
reviews to [email protected]
Point Cut
Create precise layers when using DCurve by Antonio Tarrell. Approach the haircut the same as if you were using a straight comb. The difference using a straight comb and a curvature comb is that your able to see how the hair will fall before you cut the hair.
Create this look by droping as much hair into the comb as possible and go in with the shears and point cut removing and seperating the ends at the same time. If you prefer to take smaller sections of hair you are able to do this as well.
Event/item
Position
Event/item
The more you pratice with DACurve by Antonio Tarrell the more haircutting will become fun and easy.
The picture above the hair is elevated slightly at 2 o'clock with the side panel and top panel insirted into the comb. Go in with the shears and point cut. Repeat these steps all around the head until desired cut is achieved.
Sides
The above image was created by taking the entire side panel with the hair insirt into the comb in a convex position. Second, take desired clippers and follow the spine of the comb making sure the teeth of the clippers is touching comb at all time. Continue with the next panel and repeat steps as needed.
Adding texture
This look was crerated with the curvature of the comb held in a vertical positin.
Take small vertical subsection and point cut with desired tool. Repeat this step as needed.
Remember DACurve by Antonio Tarrell is not design to replace any other comb but it was designed to make hair cutting faster and more ergonomical.
As you can see by holding the comb in this position you are able to create rounded layers instant.
Remove length and add texture at the same time with DACurve by Antonio Tarrell