UTCJ THEOREMA Revista científica Theorema 6ta edición especial | Page 7

ANÁLISIS DE ENGRANES RECTOS PERFIL INVOLUTA DE C A LC U L A D O S P O R E L M É TO D O D E L E L E M E N TO F I N I TO Y E S TA N D A R E S AG M A Jorge Carlos León Anaya 1 , César Hernández Martínez 2 y Jafeth Rodríguez Ávila 3 Universidad Politécnica del Valle de México. Av. Mexiquense, S/N, Esquina Universidad Politécnica, Tultitlán, Estado de México, México, C.P. 54910. 1,2,3 [email protected] Resumen: El objetivo de este trabajo es comparar el esfuerzo de flexión que se presenta en el diente de un engrane recto que tiene un perfil de involu- ta, calculado por el método tradicional de AGMA y el método del elemento finito (MEF). Se llevaron a cabo distintos análisis con modificaciones de materiales y condiciones de trabajo en un reductor de velocidad para una línea transportadora que tendrá una velocidad de salida de 180 revoluciones por minuto (rpm). El mecanismo analizado tiene un par de engranajes de ejes paralelos con engranes rectos de perfil involuta de 19 dientes, teniendo un paso diametral 6 para el piñón y 37 dientes con paso diametral 6 para el engrane, ambos tienen un ángulo de presión de 20 grados. + Palabras clave: Análisis, engranes rectos, Método del Elemento Finito y esfuer- zo de flexión. Recibido: Octubre 31, 2016. Recibido en forma revisada: Mayo 28, 2016. Aceptado: Mayo 22, 2017. Abstract: In this paper, a comparative of the analytical AGMA Me- thod and the Finite Element Method (FEM) for the calculation of the ben- ding stress in the tooth of straight cut gear with involute profile was de- veloped. Several analysis where made with different materials and work conditions in a gearbox for a conveyor belt, with an angular velocity of 180 rpm. The analyzed mechanism was a couple of straight cut gears; the pinion had 19 teeth with a diametral pitch of 6 and the wheel 37 teeth, both of them with a pressure angle of 20°. + Keywords: Analysis, straight cut gear, Finite Element Method and bending stress. Revista Científica 7