STEP 5:
Connect all the wires to their appropriate
places. The ground wire from the board
goes into the as-of-yet unsoldered
sleeve lug.
STEP 6:
Wire the tip lugs of the input and
output jacks to the switch. One of
these goes into the as-of-yet unsoldered
lug 9. When you fire it up, use a
screwdriver to adjust the trimpot. This
lets you set the fuzz output before it’s
boosted, which essentially lets you
decide the range of the volume knob
on the surface of the pedal.
STEP 7:
That’s a wrap! Bask in your glory!
30