STEP 2:
Run a saved lead between lugs 4 and 9
on the switch and solder lug 4. Feed the
LED’s negative leg into lug 1. If the LED
can’t reach, use a wire.
STEP 3:
This is where we ground the enclosure.
Run a wire from lugs 2 and 6 to the
negative lug on the DC jack. Solder the
switch lugs. Then, run a wire from the
negative lug on the DC jack to the sleeve
lug on either the input or output jack.
Solder the DC negative lug. Then run
a wire from the sleeve lug to the other
sleeve lug, and solder the first sleeve lug,
leaving the last one unsoldered.
STEP 4:
The pots have a tiny metal tab on
the sides that keep them from being
mounted. Break these off with pliers and
mount the pots and board.
ToneReport.com
29