ALRIGHT, LET’S DO IT!
STEP 1:
Mount the
toggle, all jacks,
LED in bezel
and footswitch.
STEP 2:
Using the last saved lead, run it between
lugs 4 and 9 of the footswitch. Solder lug
4. Insert the negative LED leg into lug
1, and attach the resistor to the positive
LED leg, then attach the other end of the
resistor to BOTH positive power lugs.
Solder only one positive power terminal.
If the LED legs aren’t long enough to
reach, use wires.
STEP 3: This is where we ground
the enclosure. The way I have it wired
affects the sweep of the wah with
expression (to fix it, both sides of
the stereo jack must be individually
grounded). Run a wire from footswitch
lugs 2 and 6 to the sleeve lug of the
stereo jack and solder the footswitch
lugs. Run a wire from one sleeve lug to
the other, soldering the first one. Then,
take turns soldering one wire to the next
ground point and soldering the previous
lug, until all ground points (jacks, DC
power and switch) are wired together.
Leave the final point unsoldered.
ToneReport.com
37