Subaru WRX & WRX STI Manuals 2018 WRX & WRX STI Owner’s Manual | Page 511

Maintenance and service/Replacing bulbs
Left-hand side
the headlight assembly by turning it clock-
wise.
4. Replace the bulb with a new one. At
this time, use care not to touch the bulb
surface.
5. To install the bulb to the headlight
assembly, turn it to the reverse direction
until it clicks.
6. Reconnect the electrical connector.
7. Left-hand side: Set the washer fluid
filler pipe to the original place and secure it
by a clip.
Right-hand side: Install the air intake
duct with clips.
11-45
2. Stop the engine.
3. Remove the clips from the mud guard.
& Low beam headlight*, front
side marker light, parking
light* and front turn signal
light*
*: models without LED headlights
NOTE
Right-hand side
3. Left-hand side: Remove the bulb
from the headlight assembly by turning it
counterclockwise.
Right-hand side: Remove the bulb from
. If headlight aiming is required, con-
sult your SUBARU dealer for proper
adjustment of the headlight aim.
. It may be difficult to replace the
bulbs. Have the bulbs replaced by your
SUBARU dealer if necessary.
4. Pull off the mud guard.
1. Start the engine and turn the steering
wheel fully in the opposite direction of the
bulb to be replaced.
– CONTINUED –