Subaru WRX & WRX STI Manuals 2018 WRX & WRX STI Owner’s Manual | Page 38

1-6
Seat, seatbelt and SRS airbags/Front seats
ble in the following ways.
! Head restraint height adjustment
1)
2)
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks. Press and hold
the release button to lower the head
restraint.
Adjust each head restraint so that the
center of the head restraint is closest to
the top of the occupant’s ears.
NOTE
When the head restraint will not move
in or out due to insufficient clearance
between the head restraint and the
roof, tilt the seat and then perform the
installation and removal tasks.
! Head restraint angle adjustment
It is possible to adjust the angle of the
head restraint in several steps. While
maintaining a suitable driving posture,
adjust the head restraint to a position
where the back of your head is as close to
the head restraint as possible.
To tilt:
Tilt the head restraint by hand to the
preferred position. A click will be audible
when the head restraint is locked.
To return:
Tilt the head restraint once as far forward
as it can go. The head restraint will
automatically return to the fully upright
position. Then, adjust the head restraint
again to the preferred angle.