Towing 401 |
||||||
threaded hole until the threads can no longer be seen . |
er operation of the SRS airbag system in a frontal collision . |
the cover and pry open the cover . |
||||
CAUTION |
||||||
To prevent deformation to the bumper and the towing hook , do not apply an excessive load to the towing hook . |
||||||
|
4 . Tighten the towing hook securely using the jack handle .
After towing , remove the towing hook from the vehicle and stow it in the under-floor storage compartment .
Fit the towing hook cover on the bumper .
|
Rear towing hook :
1 . Take out the screwdriver , towing hook and jack handle from the under-floor storage compartment .
|
3 . Screw the towing hook into the threaded hole until its thread can no longer be seen . |
In Case of Emergency
9
|
|||
WARNING |
||||||
|
. Do not use the towing hook for purposes other than towing your vehicle .
. Be sure to remove the towing hook after towing . Leaving the towing hook mounted on the vehicle could interfere with prop-
|
2 . Cover the tip of a flat-head screwdriver with vinyl tape or cloth so that it will not scratch the bumper . Insert the flathead screwdriver into the cutout of |
4 . Tighten the towing hook securely using the jack handle . |
||||
– CONTINUED – |