Remote Keyless Entry System 123 |
|||||||||
|
The hazard warning flashers flash 3 times to indicate completion of the setting .
Your SUBARU dealer can perform the above procedure for you .
& Selecting Hazard Warning Flasher Operation s02ae26
Using the hazard warning flasher , the system will give you a visible signal when the doors are locked or unlocked . If desired , you can turn the hazard warning flashers off by operating the center information display . For details , refer to “ Car settings ” FP198 ( 11.6-inch display models ) or “ Car Settings icon ” FP211 ( dual 7.0-inch display models ). The setting can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Vehicle Finder Function s02ae05
Use this function to find your vehicle parked among many vehicles in a large parking lot . Provided you are within 30 feet ( 10 meters ) of the vehicle , pressing the “ ” button three times in a 5-second period will cause your vehicle ’ s horn to sound once and its hazard warning flashers to flash three times .
|
NOTE
If the interval between presses is too short when you press the “ ” button three times , the system may not respond to the signals from the remote transmitter .
& Sounding a Panic Alarm s02ae06
To activate the alarm , press the “ PANIC ” button once .
The horn will sound and the hazard warning flashers will flash .
To deactivate the panic alarm , press any button on the remote transmitter . If a button on the remote transmitter is not pressed , the alarm will be deactivated after approximately 30 seconds .
& Replacing the Battery
Refer to “ Replacing Battery ” FP460 .
s02ae08
& Replacing Lost Transmitters s02ae09
If you lose a transmitter or want to purchase additional transmitters ( up to four can be programmed ), you should reprogram all your transmitters for security reasons . For details , contact your SUBARU dealer and have the transmitters programmed into the remote keyless entry system .
|
& Certification for Remote Keyless Entry System s02ae18
. U . S . -spec. models FCC ID : CWTB1G496 FCC ID : CWTD1G141
CAUTION
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user ’ s authority to operate the equipment .
This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions : ( 1 ) This device may not cause harmful interference , and ( 2 ) this device must accept any interference received , including interference that may cause undesired operation .
|
2
Keys and Doors
|
||||||
– CONTINUED – |