122
Remote Keyless Entry System
If desired , you can turn the hazard warning flashers off by operating the center information display . For details , refer to “ Car settings ” FP198 . The setting can also be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Locking the Doors s02ae01
Press the “ ” button to lock all the doors ( including the fuel filler lid ). An electronic chirp will sound once and the hazard warning flashers will flash once .
If any of the doors is not fully closed , the following will occur to alert you that the doors are not properly closed .
. An electronic chirp sounds five times .
. The hazard warning flashers flash five times .
When you close the door , it will automatically lock and then the following will occur .
. An electronic chirp sounds once .
. The hazard warning flashers flash once .
& Unlocking the Doors s02ae02
Press the “ ” button to unlock the driver ’ s door and fuel filler lid . An electronic chirp will sound twice and the hazard warning flashers will flash twice . To unlock all the doors , briefly press the “ ” button again within 5 seconds .
NOTE
If the interval between the first and second presses of the “ ” button for unlocking all the doors is extremely short , the system may not respond .
& Opening the Trunk Lid s02ae13
Press and hold the “ ” button to open the trunk lid . An electronic chirp will sound twice and the hazard warning flashers will flash twice .
This operation setting can be changed by a SUBARU dealer . Consult your SUBARU dealer for details .
& Setting Audible Signal Operation s02ae07
Using an electronic chirp , the system will give you an audible signal when the doors lock and unlock .
Models with “ keyless access with push-button start system ”:
If desired , you can turn the audible signal off by operating the center information display . For details , refer to “ Car settings ” FP198 . Furthermore , the volume setting of the audible signal can also be changed
by a SUBARU dealer . Consult your SUBARU dealer for details .
Models without “ keyless access with push-button start system ”:
Perform the following steps to deactivate the audible signal . Take the same steps to restore the function .
Steps |
Operation |
Time |
1 |
Sit in the driver ’ s seat . |
— |
2 |
Close all doors . |
— |
Press and hold “ |
” on |
( 1 ) |
the power locking switch . |
3
4
( 2 )
Insert the key into the ignition switch and pull it out at least 6 times .
Open and close the driver ’ s door .
Within 10 sec .
Within 10 sec .