Interior equipment
opener by pressing the programmed
HomeLink® button.
& Programming other devices
6-21
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 10 seconds).
Rear view camera (if
equipped)
2. Release both buttons.
A rear view camera is attached to the rear
gate. When the ignition switch is “ON” and
the select lever is set to “R”, the rear view
camera automatically displays the rear
view image behind the vehicle on the
navigation monitor or on the inside mirror.
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
or call 1-800-355-3515.
& Operating the HomeLink®
Wireless Control System
Once programmed, the HomeLink® Wireless Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate button. The indicator light illuminates, indicating that the signal is being transmitted.
& Erasing HomeLink® button
memory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink® buttons be
erased for security purposes.
& In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink® button after
programming, contact HomeLink at
www.homelink.com or call 1-800-3553515 for assistance.
WARNING
. Since the rear view camera uses
a wide-angle lens, the image on
the monitor is different from the
actual view in terms of distance.
. Since the range of the image on
the monitor is limited, you should
always check the rear view and
– CONTINUED –