6-20
Interior equipment
System and your garage door opener
should activate when the HomeLink ®
button is pressed.
& Programming for entrance
gates and garage door openers in Canada
the procedure in step 2.
3. Hold the end of the entrance gate’s/
garage door opener’s hand-held transmitter between 1 and 3 inches (25 and 76
mm) away from the HomeLink® buttons on
the driver’s sun visor, keeping the indicator light in view.
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
1)
Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the “training light” on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press and
release the HomeLink® button that was
programmed in the section above. Press
and release the button a second time to
complete the programming procedure.
NOTE
Some garage door openers may require you to do the above procedure a
third time to complete the programming.
4. The garage door opener should now
recognize the HomeLink® Wireless Control
2. Press and hold the two outside buttons
until the HomeLink® indicator light begins
to flash (after 10 seconds). Release both
buttons.
NOTE
When reprogramming any of the
HomeLink® buttons that are already
programmed for other devices, perform
4. Press and hold the desired HomeLink®
button.
5. Press and release (“cycle”) the handheld transmitter button every 2 seconds
until step 6 is complete.
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door