5-4 . Using the driving support systems
357
WARNING
●Do not subject the camera vicinity to strong impacts . If the vicinity is subjected to a strong impact , have the vehicle
inspected by your SUBARU dealer .
●Do not disassemble , remodel or paint the camera .
●Do not attach accessories or stickers to the camera .
●Do not install market protection parts ( bumper trim , etc .) to the
rear bumper .
● Maintain suitable tire air pressure .
●Make sure the back door is completely closed .
■ RCD function is turned off
In the following situations the system turns off . The RCD function may not operate properly and thus there is the danger that an accident may occur .
●The contents mentioned above are not observed
●Suspensions other than the genuine parts are installed
System component Location of the rear camera
RCD display
Pedestrian detection icon
Displayed automatically when a pedestrian is detected behind the vehicle .
Turning the RCD function on / off
The RCD function can be enabled / disabled through a customize setting . ( �P . 608 )
When the RCD function is disabled , the driving assist information indicator ( �P . 150 ) illuminates , and a message is displayed on the multi-information display .
Each time the power switch is turned off then changed to ON , the RCD function will be enabled automatically .
5
Driving
When a pedestrian is detected
If a pedestrian is in the area behind the vehicle or if the rear camera detected that a pedestrian is approaching the vehicle