132 2-2 . Charging
■ The error warning indicator on the CCID ( Charging Circuit Interrupting Device ) flashes
Likely cause
Electrical leakage detection function or self-diagnostic function operates and power is cut off
Correction procedure
When the voltage is insufficient , the error warning indicator may flash when there is noise interference . Perform a reset and connect to a proper power source . ( �P . 90 )
If charging does not start , immediately stop charging and contact your SUBARU dealer .
■ Charging indicator of the charging port does not illuminate , even though AC charging connector is connected .
Likely cause
AC charging connector is not securely connected to AC charging inlet
Traction battery is already fully charged
Correction procedure
Check the connection status of the AC charging connector .
• When connecting the AC charging connector , make sure not to touch the latch release button . Insert the AC charging connector securely until you hear a click . The AC charging connector may not be connected correctly if the latch release button is pressed while inserting .
• After connecting the AC charging connector , check that the latch release button is not pressed and the charging indicator of the charging port is turned on .
If the charging indicator of the charging port does not illuminate , even though the AC charging connector is securely connected , there may be a malfunction in the system . Immediately stop charging and contact your SUBARU dealer .
When the traction battery is fully charged , charging is not performed .