176 4-2 . Opening , closing and locking the doors
■ Power back door operating conditions
The power back door can automatically open and close under the following conditions :
●When the power back door system is enabled . ( �P . 180 )
●When the power switch is in ON , in addition to the above for the
opening operations , the back door operates for any of the following conditions :
• Parking brake is engaged
• The brake pedal is depressed
• The shift position is in P .
■ Operation of the power back door
●A buzzer sounds and the emergency flashers flash twice to indicate that the back door is opening / closing .
●When the power back door system is disabled , the power back
door does not operate but it can be opened and closed by hand .
●When the power back door automatically opens , if an abnormality due to people or objects is detected , operation will stop .
■ Jam protection function
Sensors are equipped on both sides
of the power back door . If anything obstructs the power back door while it is closing , the back door will automatically operate in the opposite direction or stop .
■ Fall-down protection function
While the power back door is opening automatically , applying excessive force to it will stop the opening operation to prevent the power back door from suddenly shutting .
■ Back door closing assist If the back door is lowered manually when the back door is stopped at an open position , the back door will fully close automatically .
■ Back door reserve lock function
This function is a function which reserves locking of all doors , beforehand , when the power back door is open .
When the following procedure is performed , all the doors except the
power back door are locked and then power back door will also be locked at the same time it is closed .
1 Close all doors , except the back door .
2 During the power back door closing operation , lock the doors using the smart key system from
the side doors ( �P . 165 ) or the wireless remote control . ( �P . 165 )
Operation signals will indicate that all the doors have been closed and locked ( �P . 166 ).
●If the electronic key is placed
inside the vehicle after starting a close operation via the door reserve lock function , the electronic key may become locked inside the vehicle .
●If the power back door does not fully close due to the operation of the jam protection function , etc .,
while the back door is automatically closing after a door reserve lock operation is performed , the
door reserve lock function is canceled and all the doors will unlock .
●Before leaving the vehicle , make sure that all the doors are closed and locked .
■ Close & lock function
When the power back door is open ,
this function closes the power back door and then locks all of the doors