36
Front Seats
A chirp will sound once , and the seat position and outside mirror angle will be registered .
NOTE
If a new position is registered for the same button , the previously registered memory position is deleted .
! Registration of the reverse tiltdown mirror angle with button “ 1 ” or “ 2 ” s01aa020706
CAUTION
Depress the brake pedal when registering the reverse tilt-down mirror angle .
1 . Move the select lever to the “ R ” position , then the outside mirror angle on the passenger ’ s side will move to the reverse tilt-down position .
2 . Adjust the outside mirror angle on the passenger ’ s side . For details about the settings , refer to “ Remote control mirror switch ” FP301 .
3 . Move the select lever to the “ P ” position , then the outside mirror angle will return to its original position .
4 . Register the adjusted positions by either of the following procedures .
. Press the “ SET ” button , then press either “ 1 ” or “ 2 ” until a chirp sounds within 5 seconds .
. While pressing and holding the “ SET ” button , press either “ 1 ” or “ 2 ” until a chirp sounds within 5 seconds .
A chirp will sound once , and the seat position and outside mirror angle on the passenger ’ s side will be registered .
NOTE
. The outside mirror angle will return to its original position approximately 9 seconds after the select lever is moved to any position other than “ R ” position .
. The factory setting ( default setting ) for this function is set as the front passenger ’ s side mirror . The setting of the driver ’ s side mirror operation can be changed by a SUBARU dealer . Contact your SUBARU dealer for details .
! Registration of memory position with an access key fob ( if equipped ) s01aa020703
1 . Adjust the memory position under the following conditions . . The parking brake is applied .
. The ignition switch is in the “ LOCK ”/ “ OFF ” position .
. The select lever is in the “ P ” position .
2 . Hold the access key fob and press and hold the “ SET ” button . Then press the “ ” button of the access key fob .
A chirp will sound once , and the memory position is registered .
NOTE
When registering the seat position , carry the access key that you want to register with you . If you are carrying 2 or more access keys , registration may not be possible .