Light Control Switch 263 |
||||||
|
parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
“” position:
Instrument panel illumination, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are on.
|
“” position: Auto on / off headlights
When the ignition switch is in the“ ON” position, the instrument panel illumination, headlights, parking lights, front side marker lights, rear side marker lights, tail lights and license plate lights are automatically on or off depending on the level of the ambient light.
NOTE
. If the light control switch is in the“ AUTO” position and the headlights do not turn on when it becomes dark outside, turn the light switch to the“” position. If this happens, have your vehicle inspected by your SUBARU dealer as soon as possible.
. The light sensitivity of the auto on / off headlights can be changed by operating the center information display. For details, refer to“ Car settings” FP232( 11.6-inch display models) or“ Car Settings icon”
|
FP251( dual 7.0-inch display models). Also, the setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
! Auto-on / off wiper-linked headlights s03ah0106
While the light control switch is in the“ AUTO” position, the headlights will automatically turn on when the windshield wipers operate several times. The headlights will automatically turn off approximately 1 minute after the wiper stops.
The ON / OFF setting of this function can be changed by operating the center information display. For details, refer to“ Car settings” FP232( 11.6-inch display models) or“ Car Settings icon” FP251( dual 7.0-inch display models). Also, the setting can be changed by a SUBARU dealer. Consult your SUBARU dealer for details.
! Welcome lighting function s03ah0103
The welcome lighting function turns on the low beam headlight for smooth approaching to or exiting from the vehicle at night or in a dark place.
The function is activated while all of the following conditions are met.
. The light control switch is in the“ AUTO” position.
. It is dark enough to turn on the auto on /
|
off headlights.
NOTE
If the engine is turned off after turning off the light switch, the welcome lighting function may not operate( for Canada models).
! When approaching s03ah010301
While the welcome lighting function is activated, the low beam headlights will automatically illuminate when unlocking the doors( for Outback / Subaru Outback Wilderness, including the rear gate) by using the remote keyless entry system.
The low beam headlights will remain illuminated for 30 seconds * 1 and then turn off. However, if any of the following operations is done, the low beam headlights will turn off.
. The doors are locked.
. The light control switch is turned to a position other than“ AUTO”.
. The ignition switch is turned to the“ ON” position.
! When exiting s03ah010302
While the welcome lighting function is activated, the low beam headlights will remain illuminated even when either of the following operation is done.
|
3
Instruments and Controls
|
||
– CONTINUED – |