|
When the access key fob is within either of the operating ranges of the front doors, the LED indicator on the access key fob flashes. When the keyless access functions are disabled, the LED indicator does not flash unless a button on the access key fob is pressed.
NOTE
. If the access key fob is placed too close to the vehicle body, the keyless access functions may not operate properly. If it does not operate properly, repeat the operation from farther away.
. If the access key fob is placed near the ground or in an elevated location from the ground, even if it is in the indicated operating range, the keyless access function may not operate properly.
. When the access key fob is within the operating range, it is possible for anyone, even someone who is not carrying the access key fob, to operate the keyless access function. Note that the keyless access function can be operated only by the door handle, door lock sensor, rear gate opener button or rear lock button in the operating range in which the access key fob is detected.
|
. It is not possible to lock the doors, rear gate and fuel filler lid using the keyless access function when the access key fob is inside the vehicle. However, depending on the status of the access key fob and the environmental conditions, the access key fob may be locked inside the vehicle. Before locking the vehicle, make sure that you have the access key fob.
. When the battery of the access key fob is discharged, or when operating it in a location with strong radio waves or noise( e. g., near a radio tower, power plant, broadcast station or an area where wireless equipment is used), or while talking on a cell phone, the operating ranges may be reduced, or the keyless access function may not operate. In such a case, perform the procedure described in“ Locking and Unlocking” FP502.
. The doors may lock or unlock when the car is being washed or exposed to a significant amount of water that touches the door handle while the key fob is still in the operating range.
! How to lock and unlock s02ap0108
It is possible to perform the following operations when you are carrying the
|
access key fob.
. Lock and unlock the doors and the fuel filler lid.
. Unlock the trunk lid( Legacy).
. Unlock and lock the rear gate( Outback / Subaru Outback Wilderness).
NOTE
. It is not possible to lock the doors, rear gate and fuel filler lid using the keyless access function when the push-button ignition switch is in the“ ACC” or“ ON” position. Refer to“ Switching Power Status” FP177.
. If the door handle is gripped with a gloved hand, the door lock may not be released.
. If the door lock sensor is touched three times or more repeatedly, the system will ignore the sensor operation.
. When performing the locking procedure too quickly, locking may not complete. After performing the locking procedure, it is recommended to pull the rear door handle to confirm that the doors have been locked.
. If any of the doors( or the rear gate) are not fully closed, the following will occur to alert you that the doors( or the rear gate) are not properly closed.
– CONTINUED –
|
2
Keys and Doors
|