! Programming a New HomeLink ® button s03ap100301 |
3 |
|||||||
|
1 HomeLink ® indicator light 2 HomeLink ® buttons
1 . Press and release the HomeLink ® button that you would like to program . The HomeLink ® indicator light will flash orange slowly ( if not , refer to “ Erasing HomeLink ® buttons ” FP281 ).
|
1 Garage door opener remote
2 . Position the hand-held remote ( garage door opener remote ) 1 to 3 inches ( 2 to 8 cm ) away from the HomeLink ® button that you would like to program .
NOTE
Some hand-held remotes ( garage door opener remotes ) may actually train better at a distance of 6 to 12 inches ( 15 to 30 cm ). Keep this in mind if you have difficulty with the programming process .
|
3 . While the HomeLink ® indicator light is flashing orange , press and hold the hand-held remote button . Continue pressing the hand-held remote button until the HomeLink ® indicator light changes from orange to green . You may now release the hand-held remote button .
NOTE
Some devices may require you to replace this “ Programming a New HomeLink ® button ” step 3 with procedures noted in the “ Gate Operator / Canadian Programming ” section . Refer to “ Gate Operator / Canadian Programming ” FP281 .
|
Instruments and Controls |
|||||
– CONTINUED – |