Subaru Outback Manuals 2022 Outback EyeSight Driving Assist System Manual | Page 114

Conventional Cruise Control
( 2 ) Switch to Conventional Cruise Control . Press and hold the / ( Following distance setting ) switch for approximately 2 seconds or longer to switch from Adaptive Cruise Control to Conventional Cruise Control . A notification sounds 1 short beep . At this time , the following distance setting indicator on the EyeSight display area of the combination meter display turns off and ( Conventional Cruise Control indicator ) ( white ) is displayed .
S03397
Conventional Cruise Control indicator ( white )
S03431
To set the ready status : Conventional Cruise Control can be activated when all of the following conditions are met and ( READY indicator ) is displayed on the EyeSight display area . - All doors ( except the rear gate / trunk ) are closed . - The driver ’ s seatbelt is fastened . - The electronic parking brake is not engaged . The electronic parking brake indicator light is turned off .
- The select lever is in the “ D ” or “ M ” position . - The brake pedal is not depressed . - The road is not on a steep slope .
READY indicator
S03432
- The steering wheel has not been turned significantly in either direction . - The X-MODE is not turned on ( the X-MODE indicator goes off ). ( if equipped ) - The vehicle speed is between approximately 20 mph ( 30 km / h ) and 90 mph ( 145 km / h ).
112