34
Front Seats
position and outside mirror angle on the
passenger’s side will be registered.
! Registration of the reverse tiltdown
mirror angle with button
“1” or “2”
s01aa020706
CAUTION
Depress the brake pedal when registering
the reverse tilt-down mirror
angle.
1. Move the select lever to the “R”
position, then the outside mirror angle on
the passenger’s side will move to the
reverse tilt-down position.
2. Adjust the outside mirror angle on the
passenger’s side. For details about the
settings, refer to “Remote control mirror
switch” ☞P265.
3. Move the select lever to the “P”
position, then the outside mirror angle will
return to its original position.
4. Register the adjusted positions by
either of the following procedures.
. Press the “SET” button, then press
either “1” or “2” until a chirp sounds
within 5 seconds.
. While pressing and holding the
“SET” button, press either “1” or “2”
until a chirp sounds within 5 seconds.
A chirp will sound once, and the seat
position and outside mirror angle on the
passenger’s side will be registered.
NOTE
. Approximately 9 seconds after the
select lever is moved to any position
other than “R” position.
. The factory setting (default setting)
for this function is set as the front
passenger’s side mirror. The setting of
the driver’s side mirror operation can
be changed by a SUBARU dealer.
Contact your SUBARU dealer for details.
! Registration of memory position
with a access key fob (if
equipped)
s01aa020703
1. Adjust the memory position under the
following conditions.
. The parking brake is applied.
. The ignition switch is in the “LOCK”/
“OFF” position.
. The select lever is in the “P” position.
2. Hold the access key fob and press and
hold the “SET” button. Then press the “ ”
button of the access key fob.
A chirp will sound once, and the memory
position is registered.
! Registration of the reverse tiltdown
mirror angle with the key
fob
s01aa020707
CAUTION
Depress the brake pedal when registering
the reverse tilt-down mirror
angle.
1. Move the select lever to the “R”
position, then the outside mirror angle will
move to the reverse tilt-down position.