142
Alarm System
– Press the rear gate opener button
(Outback).
– Press the trunk opener button
(Legacy).
– Unlock using the PIN code access.
The flashing of the security indicator light
will then change slowly (once approximately
every 3 seconds from twice approximately
every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
s02af0501
If you cannot disarm the system using the
access key fob/transmitter (i.e., the transmitter
is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
The system can be disarmed if you turn the
ignition switch from the “LOCK”/“OFF”
position to the “ON” position with a
registered key/access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the access
key fob battery is discharged,
perform the procedure described in
“Switching Power Status” ☞P459. In
such a case, replace the battery immediately.
Refer to “Replacing Battery
of Access Key Fob” ☞P517.
& Alarm System Setting
s02af11
To change the setting of your vehicle’s
alarm system for activation or deactivation,
do the following.
1. Disarm the alarm system. Refer to
“Disarming the System” ☞P141.
2. Sit in the driver’s seat and shut all
doors, the rear gate (Outback), the trunk lid
(Legacy) and engine hood.
3. Turn the ignition switch to the “ON”
position.
4. Hold down “ ” of the driver’s power
door locking switch, open the driver’s door
within the following 1 second, and wait 10
seconds without releasing the switch. The
setting will then be changed as follows.
Setting
status
Combination
meter display
(color LCD)
Horn
Activate AL ON Once
Deactivate AL OFF Twice
NOTE
You may have the above setting change
done by your SUBARU dealer.
& If You Have Accidentally
Triggered the Alarm System
s02af03
! To stop the alarm
s02af0301
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the “ON”
position (models without “keyless access
with push-button start system”).
. Turn the push-button ignition to the
“ACC” position (models with “keyless
access with push-button start system”).
NOTE
Only registered keys will stop the
alarm. If the immobilizer transponder
is not registered, the alarm will not
stop.
& Valet Mode
s02af06
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate (Outback) and panic activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system to
deactivation mode. Refer to “Alarm System
Setting” ☞P142. The security indicator
light will continue to flash once every 3