Alarm System 141
. Locking using the power door locking
switch. For details, refer to “Locking
using power door locking switch”
☞P137.
. Locking using the rear lock button.
For details, refer to “Locking with the
rear lock button (Outback)” ☞P120.
. Locking using the power rear gate
lock button. For details, refer to “Locking
with the power rear gate lock button
(Outback – if equipped)” ☞P120.
Security indicator light
NOTE
. All doors, the rear gate (Outback)/
trunk lid (Legacy) and fuel filler lid will
lock, an electronic chirp will sound
once, the hazard warning flashers will
flash once, and the security indicator
light will start flashing rapidly.
. If any of the doors or the rear gate
(Outback)/trunk lid (Legacy) is not fully
closed, an electronic chirp sounds five
times and the hazard warning flashers
flash five times to alert you that the
doors (or the rear gate (Outback)/trunk
lid (Legacy)) are not properly closed.
When you close the door, doors will
automatically lock and the system will
automatically arm in 30 seconds.
5. Approximately 30 seconds later, the
system will enter surveillance state.
When the system is in surveillance state,
the security indicator light will then flash
slowly (twice approximately every 2 seconds),
indicating that the system has been
armed for surveillance.
NOTE
. The system can be armed even if the
windows and/or moonroof are open.
Always make sure that they are fully
closed before arming the system.
. The 30-second standby time can be
eliminated if you prefer. Have it performed
by your SUBARU dealer.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveillance
state.
– Doors (including the rear gate
(Outback)/trunk lid (Legacy)) are
unlocked using the access key fob/
remote transmitter.
– Doors (including the rear gate
(Outback)/trunk lid (Legacy)) are
unlocked using the keyless access
function (models with “keyless access
with push-button start system”).
– Any door (including the rear gate
(Outback) and engine hood) is
opened.
– The ignition switch is turned to
the “ON” position (models without
“keyless access with push-button
start system”).
– Push-button ignition switch is
turned to the “ACC” position (models
with “keyless access with pushbutton
start system”).
& Disarming the System
s02af05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob/remote
transmitter.
. Carry the access key fob and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– CONTINUED –
2
Keys and Doors