Subaru Outback Manuals 2011 Outback Owner's Manual | Page 401

Maintenance and service Installation of accessories Always consult your SUBARU dealer before installing fog lights or any other electrical equipment in your vehicle. Such accessories may cause the electronic system to malfunction if they are incorrectly installed or if they are not suited for the vehicle. We recommend that you install only genuine SUBARU accessories on your vehicle. Replacing bulbs WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining a burn injury. CAUTION Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire. For the specified wattage of each bulb, refer to “Bulb chart” F12-10. 11-49 prints or grease on the bulb surface, wipe them away with a soft cloth moistened with alcohol. NOTE . If headlight aiming is required, consult your SUBARU dealer for proper adjustment of the headlight aim. . It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. ! Low beam light bulbs 1. Pull off the fender lining. For details, refer to “Pulling off the fender lining” F117. & Headlight CAUTION Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spots, causing the bulb to break. If there are finger- 2. Remove the bulb cover, by turning it – CONTINUED –