366
Remote Engine Start System ( Dealer Option )
& Entering the Vehicle While It Is Running via Remote Start ( Models with “ Keyless Access with Push-Button Start System ”) s07az24
1 . Unlock the vehicle doors using the keyless access function and remote keyless entry system .
NOTE
If the vehicle ’ s doors are unlocked manually using the key , the vehicle ’ s alarm system will trigger ( if the alarm system is armed prior to activating the remote engine start system ) and the engine will turn off . Perform either of the following procedures to disarm the alarm system . Refer to “ Alarm System ” FP143 . – Turn the push-button ignition switch to the “ ACC ” or “ ON ” position . – Press any button on the access key fob .
2 . Enter the vehicle . The engine will remain running provided the access key fob is present and detected by the vehicle .
3 . Press the push-button ignition switch once while depressing the brake pedal before driving your vehicle . The remote engine starter transceiver ( fob ) will flash and beep 3 times to indicate that the remote start system has been shut down .
& Entering the Vehicle Following Remote Engine Start Shutdown s07az10
An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown .
& Pre-heating or Pre-cooling the Interior of the Vehicle s07az04
Before exiting the vehicle , set the temperature controls to the desired setting and operation . After the system starts the engine , the heater or air conditioning will activate and heat or cool the interior to your setting .
& Remote Transmitter Program ( Remote Engine Starter Transceiver ) s07az13
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost , stolen , damaged or additional transmitters are desired ( the system will accept up to eight transmitters ). New remote engine start transmitters can be programmed according to the following procedure .
1 . Open the driver ’ s door ( the driver ’ s door must remain open throughout the entire process ).
2 . Depress and hold the brake pedal .
3 . Turn the ignition switch to “ ON ” then “ LOCK ”/“ OFF ”, back to “ ON ” then “ LOCK ”/ “ OFF ”, back to “ ON ” then “ LOCK ”/“ OFF ”, then back to “ ON ” again and leave the ignition “ ON ” throughout the programming process .
4 . The system will flash the side marker lights , tail lights and parking lights and honk the horn three times , indicating that the system has entered the transmitter learn mode .
5 . Press and release the “ ” button on the transmitter that you want to program .
6 . The system will flash the side marker lights , tail lights and parking lights and honk the horn one time , indicating that the system has learned the transmitter . Upon successful programming , the remote start confirmation transmitter button will flash one time .
7 . Repeat step 5 for any additional transmitters ( the system will accept up to eight transmitters ).
8 . The system will exit the transmitter learn mode if the key is turned to the “ LOCK ”/“ OFF ” position , the door is closed