& Alternate Operation Method for Models with “ Keyless Access with Push-Button Start System ” s07az22 |
Access key fob 1 ) Lock button
An access key fob can be used as the remote engine start transmitter . Operate the lock button to start or stop the engine as follows .
! Before starting the engine s07az2201
Before using the remote engine start system to start the engine , confirm the following conditions .
. The select lever is in the “ P ” position .
. All doors including the rear gate are closed .
|
. The engine hood is closed .
. The push-button ignition switch is in the “ OFF ” position .
! Starting the engine s07az2202
To start the engine with remote engine start system , briefly press the lock button twice within 2 seconds , then press and hold the lock button for 3 seconds .
1 . Press the lock button briefly . The hazard warning flashers then flash once and the keyless buzzer chirps once .
2 . Within 2 seconds , press the lock button briefly again . The hazard warning flashers then flash once again , and the keyless buzzer chirps once again .
3 . After step 2 , immediately press and hold the lock button . The hazard warning flashers then flash three times , and the horn will honk once .
4 . Approximately 3 seconds after step 3 , release the lock button . The engine will then start successfully .
! Stopping the engine s07az2203
Press and hold the lock button to stop the engine with remote engine start system .
! Remote start safety features s07az2204
For detailed information , refer to “ Remote start safety features ” FP363 .
|
& Entering the Vehicle While It Is Running via Remote Start ( Models without “ Keyless Access with Push-Button Start System ”) s07az03
1 . Unlock the vehicle doors using the remote keyless entry system .
NOTE
If the vehicle ’ s doors are unlocked manually using the key , the vehicle ’ s alarm system will trigger ( if the alarm system is armed prior to activating the remote engine start system ) and the engine will turn off . Perform either of the following procedures to disarm the alarm system . Refer to “ Alarm System ” FP143 . – Insert the key into the ignition switch and turn it to the “ ON ” position . – Press any button on the remote keyless entry transmitter .
2 . Enter the vehicle . The engine will shut down when any door or rear gate is opened .
3 . Insert the key into the ignition switch and turn it to the “ START ” position to restart the engine .
|
7
Starting and Operating
|
||
– CONTINUED – |