276
Mirrors
7 . Return to the vehicle and firmly press , hold for 2 seconds and release the HomeLink ® button up to three times . At this point programming is complete and your device should operate when the HomeLink ® button is pressed and released .
1 ) Status Indicators
8 . If status indicator arrows appear next to the indicator light , please refer to “ Garage Door Two-Way Communication ” FP277 .
In the event that there are still programming difficulties or questions , additional HomeLink ® information and programming videos can be found at www . HomeLink . com and www . youtube . com / HomeLinkGentex . For Genie and Sommer garage door openers please go directly to the HomeLink ® website .
! Gate Operator / Canadian Programming s03ap100302
Canadian radio-frequency laws require transmitter remote signals to “ time-out ” ( or quit ) after several seconds of transmission , which may not be long enough for HomeLink ® to pick up the signal during programming . Similar to this Canadian law , some U . S . gate operators are designed to “ time-out ” in the same manner . The indicator LED on the hand-held remote will go off when the device times out , indicating that it has finished transmitting .
If you live in Canada or you are having difficulties programming a gate operator or garage door opener by using the programming procedures , replace “ Programming a New HomeLink ® button ” step 3 with the following :
While the HomeLink ® indicator light is flashing orange , press and release (“ cycle ”) your device ’ s hand-held remote every two seconds until the HomeLink ® indicator light changes from orange to green . You may now release the hand-held remote button .
NOTE
If programming a garage door opener or gate operator , it is advised to unplug