3-82
Instruments and controls/Mirrors
! Reprogramming a Single
HomeLink ® button
S03AP100305
To program a previously trained button,
follow these steps:
1. Press and hold the desired HomeLink ®
button. DO NOT release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The
HomeLink ® button can be released at this
point. Proceed with “Programming a New
HomeLink ® button” - step 3.
3. If you do not complete the program-
ming of a new device to the button, it will
revert to the previously stored program-
ming.
Range may be reduced by obstacles such
as houses or trees. You may have to slow
your vehicle speed to successfully receive
the garage door opener communication.
online at www.HomeLink.com and
www.youtube.com/HomeLinkGentex.
! Using Two-Way Communication
S03AP100308
! Programming Two-Way Commu-
nication
S03AP100307
1)
! Garage Door Two-Way Commu-
nication
S03AP100306
HomeLink ® has the capability of commu-
nicating with your garage door opener.
HomeLink ® can receive and display “clos-
ing” or “opening” status messages from
compatible garage door opener systems.
At any time, HomeLink ® can also recall and
display the last recorded status commu-
nicated by the garage door opener to
indicate your garage door being “closed”
or “opened”. Within 5 seconds after programming a new
HomeLink ® button, both of HomeLink’s
garage door status indicators will flash
rapidly green indicating that the garage
door two-way communication has been
enabled. If your garage door status in-
dicators flashed, two-way communication
programming is complete.
HomeLink ® has the capability of receiving
this communication from the garage door
opener at a range up to 820 feet (250 m). If the garage door status indicators do not
flash, additional HomeLink ® information
and programming videos can be found
1)
Status Indicators
Status Indicator
Recall and display (at any time) the last
recorded garage door status message
communicated to HomeLink ® by simulta-
neously pressing HomeLink ® buttons 1
and 2 for 2 seconds. HomeLink ® will
display the last recorded status for 3
seconds.